Dual Mode Windup Car with windows.

Discussion in 'Show off' started by biline, Apr 21, 2017.

  1. biline

    biline Active Member

    Joined:
    Apr 13, 2016
    Messages:
    25
    Likes Received:
    21
    This a slight remix I made of a Dual Mode Windup Car by gzumwalt
    http://www.thingiverse.com/thing:2262946

    I loved the design but after printing the first one and showing it to friends and family I noticed they didn't know which end was the front. I thought maybe if it had some head lights it would make it more clear I ended up also added a dual exhaust to it also. I did all these changes with Tinkercad, it was a learning experience but I'm happy with the results but I do need to spend time with Fusion 360.
    I printed everything at .02mm in PLA with 80% infill with 4 perimeters on Top, Bottom and Sides.

    IMG_5249.JPG IMG_5250.JPG IMG_5252.JPG IMG_5254.JPG IMG_5271.JPG IMG_5280.JPG IMG_5284.JPG IMG_5307.JPG IMG_5313.JPG IMG_5318.JPG IMG_5329.JPG IMG_5332.JPG IMG_5345.JPG IMG_5366.JPG IMG_5380.JPG IMG_5386.JPG
     

Share This Page