Separate names with a comma.
I'm looking for suggestions for a replacement of the original Titan extruder that's on my v1.1 single head Bigbox. Ideally something...
Hi Folks, I have an original v1.1 single extruder E3D Bigbox Pro. It was factory built for me as part of the first batch of sales following the...
So it turned out to be even easier than first thought! I had to fiddle with the wiring a bit to begin with because (as it turns out) the...
Will do. Plenty of time for testing at the moment!
Thanks, that looks pretty straightforward, I don't have a duex so it'll be going straight into the Duet. I chose this one because it seems to be...
Hi All, hope everyone is well in these odd times. I've just ordered a TriangleLab filament rumour sensor -...
I did it a few months ago. My advice: label everything! I would also recommend crimping new connectors on to the ends of all the wires, the ones...
Thanks, adding some grease was all it needed, guess I completely overthought what was wrong!
Ok I think I'm there, just a tiny bit of blobbing to reduce, but I've obviously gone slightly too far with the extra restart distance. I have one...
Fantastic, that's really helpful! I do have a Duet, so I'll start reading up on M207, but in the meantime I may produce some specific test prints...
Ok, one nasty bodge later and I'm printing! Thanks @Spoon Unit , I'm not sure whether I would have just taken the plunge and cut the part in half...
I think you're right, I'm going to have to cut it in half and patch on an extension! Can you please post a link to the stl file for that piece?
Ok, I'll try to keep this as brief as possible :rolleyes: So following a problem with my standard v6 hot end which has meant that I can't remove...
Thanks, here you go [MEDIA]
Ok, is it valid to add further questions to this thread, or should I start another? Here's the thing: First three prints everything was fine,...
Success! I have printed a cube and a benchy and all seems well so far. I can't believe how much quieter it is! Thanks for all the help. :)
By way of an update: Firstly, when I switched it on, it didn't go fizz pop, so that was win number one. So this evening I have, Updated the...
Will do, thanks for all your help.
Ok, since posting the previous photos I've revisited and taken your advice (well, even more of your advice than before!), and have replaced all...
Hi All, thanks for all your help so far, hope the wiring looks better now? I just wanted to ask if you can point me in the right direction of a...