Separate names with a comma.
Great Work Björn! I started ordering the parts for the IDEX upgrade of my scratchbuilt BB. Two questions: 1. I thought it is important to keep...
Did you mean broken wires? I will check the wires!
Yes, and I put a drop of thread locking paint on to notice any movement.
I have sporadically horizontal offsets during the print. Sometimes after many hours. In the image below it is a 3mm X-shift after 13h print time....
I already checked the Extrusion rate. I calculated the relativ extrusion from point to point and divided throu the total (X+Y) relative movement...
Have the issue with both USB (Repetier) and SD card
I continued the investigation of my issue. I looked closer at the gcode and plotted the path of one outer wall. At the position where the speed...
If I remember right, I had this issue with RC8 but the speed drops where more noticeable there and over a longer period. I think I solved this...
I am printing 3DLabprint RC-Planes. The Airframe consists of one outer shell and an internal structure. I rrealized irregular bumps on the outer...
Thank you! Looks good! Now I am waiting for the BLTouch sensor to arrive.
Ok, I thought I changed all necessary parameters in configuration.h and configuration_adv.h of RC8-Bigfix for my BB Dual Hybrid but I obviously...
Maybe I have a q&d solution (see above) for RC8 but I try to adapt RCBugfix to my BB Dual Hybrid Titan.
Hello markoaurelije, thank you for the fast reply! You made me aware of the existing issue. https://github.com/MarlinFirmware/Marlin/issues/5728...
I ordered a BLTOUCH sensor for my scratch built BigBox Dual Hybrid Titan because of inconsistent measurents of the IR sensor. So I tried...
At the beginning I set it to the limit of my steppers which is 1A for the direct ant 1.7A for the bowden. In the meantime Vref is 0.355V = 0.71A...
Bigbox Dual Hybrid Titan, 5mm Plexiglas 16,0 Kg
Ok, so I halved the max possible Y-Feedrate. :-( The RepRap Wiki defines following max step-rate Marlin/Repetier ATmega 16 MHz, Single...
Thank you. Looks straight forward. .....docking, purge old, prime new, and undock at every toolchange .......
No, I only get a slicer_config:bundle tab. I found some .zip files to Slic3r version 1.3.0 dev but they contain no slic3r.exe. How could I use...
Hello Tohara, I imported slic3r_config_bundle.ini to Slic3r and sliced a two color part but I couldn't find anything concerning tool-change in...