Separate names with a comma.
Well, increasing the temperature to 245, it extrudes better, still lots of missed steps, and I have to have Vref on the driver really high for it...
No not yet, I'm going to try a higher temp, and then I'll try the Melzi board as it has a different driver IC, (I think the drivers on the ramps...
It's a titan aero, with the heat sink fan running all the time. It probably was just too much retraction because I was trying to retract the...
Temp was 230 (ABS), and I was able to manually push down and extrude. The drivers were set around that .5 mark for Vref. Even tried a different...
Have you had any joy. I've just got around to installing mine and it's doing exactly the same.