Separate names with a comma.
I know there's Titan and Aero IDEX mods and carriages and whatnot flying around but has anyone designed improved part cooling for the original...
Has anyone seen the plastic part of the bowden fittings E3D uses for sale online anywhere? My Volcano hot end didn't come with one and and...
I found the original bigbox filament feed tube was always moving, caused by retraction. The built in clips in the cable brackets just never held...
I've been using automatic bed levelling since I built my bigbox. My starting gcode does an autohome, followed by a a 5 point bed level - center...
to fill the whole bed... [ATTACH]
After 5 days, 2.5 Benchys, and a tall single perimeter rocket I put loctite on all the grub screws and went for broke. 36 hours and 580g of PLA...
I modelled a little tab to secure the cutouts in place. Nothing fancy. You'll need 8 per panel. Thought others might find them useful: [ATTACH]...
It seems no matter what I do when I autohome the bed stays offset by a full MM. (using a feeler gauge) I ran through the steps on the build...
Details and discussion on how to make your extruder head assembly easily removable. The big box is great but there's a problem. It doesn't matter...
Is that not the most exciting email you can wake up to? Hope its true and not just an automated reply to any order.
August update - assembly tips and a few issues [MEDIA] September Update - working well, thoughts on changes [MEDIA] October Update - moving...
If you're still thinking about what to include as a bonus for meeting the last goal could I suggest a PEI print bed? Or at the very least could...