Separate names with a comma.
I adapted a design from thingiverse to improve the filament guidance using a standard E3D V6, and then put two of them back to back with the...
Thanks. The motors are the 50:1 geared steppers from 2Engineers http://www.2engineers.com/shop/geared-steppermotor-wire-length-1-m/
[IMG] Here's my direct drive chimera, which works a treat.
I get z banding caused (I think) by nozzle wobble due to the length of the Volcano. So - any ideas? I am thinking of printing a support for the...
That does help make detachable supports, although even using a width of 0.5mm (Half the nozzle diameter) I still need to use pliers to "detach"...
I've been advised on another forum to reduce the width of the support material (using Slic3r advanced settings) to half the nozzle width. I'll...
I'm printing using support material,and am having real problems removing the supports. I'm using ABS with a 1mm nozzle and a support pattern in...