Separate names with a comma.
Hello I have an ender 3 that has a perfect first layer but then diminishes into horrible layers. I have the e steps calibrated and the bed is...
Hello, I been having a hell of a hard time with a Hemera upgrade on my Ender 3 V2. I am completely lost. i tried to run the Temp test from...
I recently installed my new Hemera direct drive with the standard hot end on my CR-10S The mount I used is here:...
Hi folks, just stumbled across a vid of somebody testing ripple and backlash with different kinds of rods for the gantry at the same...
E3D V6 05/11/2015 Complete Heatsink/Heatbreak/Hotend/heater/thermistor and 0.4mm nozzle - has worked well, good solid prints, no extruder...
Hey Everyone, have been trying to print the model below but for some reason the blobs and zits are very noticeable on this. Looking at the...