Separate names with a comma.
I'm trying to install the Revo on my Qidi X-plus with Bondtech direct drive extruder. Replacing the eV6 hotend. When I go to preheat nozzle shows...
Hi all, I've recently received my E3D Revo (through the reseller 3DJake), and in general, it performs really well. After some comments from...
I've just installed my Hemera (24V) direct extruder. I'm currently attempting to perform the PID tune on it and the PID autotune times out due to...
My thermistor wire broke recently and the replacement arrived, but I'm not able to get that darn grub screw out. I thought I could just heat it...
Hello all, I own a TEVO Little Monster printer that's been quite happily pushing out print after print for about a year and a half now. As stock,...
Hello! I've been using my e3d v6 for a year now and I'm loving it. In the last few days I've been having a weird issue with the temperature...
I've been using the V6-Lite for about 6 months and it's been performing for me without a problem up until now. Unfortunately I can't finish a...
TLDR: How should the Varipower bed thermistor be described in the Duet WiFi's config.g file? I was trying to understand the somewhat arcane way...
Hi, (sorry for m english) I have the e3d lite with the new version of the thermistor. I have a MKS board with different connector than the...
I have been receiving help on the seemecnc forums, however, since the support, there is starting to become counter intuitive (wrapping the e3d...
After many attempts, I continue to not receive readings from the thermistor no matter what I do. Thank you for any help/experience you can offer....
I find the current thermistor setup very fiddly, probably due to my fat fingers. This looks like it could be a good alternative if it fits into...
So I've put together a DIY printer loosely based on the Cherry 60 design and, despite having no experience in 3D printers and making some bits in...