coordinate issues with E3D UM2 upgrade

Discussion in 'General' started by lance, Apr 27, 2017.

  1. lance

    lance Well-Known Member

    Joined:
    Nov 25, 2015
    Messages:
    54
    Likes Received:
    9
    so after installing the E3D UM2 upgrade ive noticed that while the part position in the slicer is centered, once it starts printing the part is shifted to the right on the buildplate. is there some setting that can remedy this? im trying to print a part that takes up almost the entire build area and even though i know it will fit, the printer cancels itself and says it is trying to print outside of the build area even though it has lots of room and is not near the edge at all
     

Share This Page