EEPROM Reset?

Discussion in 'Calibration, Help, and Troubleshooting' started by Syko_Symatic, Jan 11, 2017.

  1. Syko_Symatic

    Syko_Symatic Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    273
    Likes Received:
    29
    When updating things like probe offsets and flashing the firware should I restore failsafe on the EEPROM? I think this may be where my problem lies with my Z probe y offset?
     
  2. Paul Begley

    Paul Begley Well-Known Member

    Joined:
    Mar 24, 2016
    Messages:
    66
    Likes Received:
    18
    Yes, i always do. Restore Failsafe will load the firmware values, else you will continue to use any previous settings stored in the firmware.
     
    Syko_Symatic likes this.

Share This Page