Soon to be E3D user/owner, but in doubt..

Discussion in 'Introductions' started by Bo Herrmannsen, Dec 17, 2016.

  1. W1EBR.Gene

    W1EBR.Gene Well-Known Member

    Joined:
    Apr 10, 2016
    Messages:
    159
    Likes Received:
    23
    Other benefits of water cooled hotends are that a multi-hotend carriage can be smaller, it won't be as strongly influenced by a heated bed and a heated chamber printer is possible (for those plastics that shrink)
     
    Jari likes this.
  2. Bo Herrmannsen

    Joined:
    Dec 17, 2016
    Messages:
    15
    Likes Received:
    0
    Not sure anymore if i will do flexible's as it sounds to hard to do

    right now i'm debating myself if i should do a dimond hotend and a single v6 on the side for water soluble support

    the trick is to get that setup compact and throw a level sensor in that does not get effected by heat or moisture etc
     
  3. Bo Herrmannsen

    Joined:
    Dec 17, 2016
    Messages:
    15
    Likes Received:
    0
    carriage itself is 55mm wide but there is a bit of room to the left

    still going after being able to reach the extreme's of the bed, ie the full 20cm in X and Y
     
  4. Bo Herrmannsen

    Joined:
    Dec 17, 2016
    Messages:
    15
    Likes Received:
    0

Share This Page