Separate names with a comma.
best option would be some sort of positive latch mechanism that is disabled by the toolchanger latching onto the tool. Don't think there is a lot...
can't you leave the bed way low while it heats up, so it does not heat up the switch....sure it will get some heat as it probes the bed, but not...
BTW, a real simple way to add a relay to control a vacuum would be the "IoT control relay" from digital loggers....
Nice, but CF filled polymer for the gears worries me. that stuff is VERY abrasive and will wear itself out. An unfilled nylon would be better for...
Anyone find a good place to add an E-stop button? Don't really need the full screen, just a simple button to stop a printer that's not doing what...
tighten the belts...this fixed many print anomalies. Also check to see if the motor belt pulleys are rubbing the side of the belt very hard. had...
Anyone using a filament sensor? which one? Don't need anything fancy, just want it to pause on filament out on first tool only, but I guess they...
plenty of touch probe designs out there. would not be too hard to make a "tool" that is a touch probe, or even a temporary tool used only for...
looks very nice. what is that aquamarine color filament?
Very Nice. If you can get the slicer to automatically mill the exterior after every layer, the cutting forces should be very small and produce...
I ended up removing the prime and purge from the duet tool change G-codes, and put it in Cura instead, seems to work better that way. Here is my...
where do you change this? code in the config.g? can you post it?
some people do it to be able to move code to different size printers without re-compile....it has it's benefits, but also down sides Also, why...
