Separate names with a comma.
very nice! how much does it weigh?
My standard bowden tools don't (when homing Y before X). If your tools do, you might want to have a little protrusion in the left front corner of...
...and what about KISSlicer? It seems to have some nice features, too. (@orcinus, are you using it?)
this recent article at least suggests, that S3D is still alive, but it doesn't give the slightest hint about a possible release date for S3D V5...
You just beat me to it buy a couple of hours :D I was going to ask the same question. I currently use Cura 4.6 for the TC primarily, mostly...
Implementing a tool-on-carriage check point would be easy. All you need for this is available and working today. Assuming you have the...
....for completeness sake, here is how I define the microswitches in config.g: ; Tool microswitches M950 J0 C"!^duex.e2stop" M950 J1...
I will switch to the paradigm outlined by @mhe but for the time being, I have the microswitches on the tools as described here. The system is now...
Everything works fine now ... almost :) It appears that upon executingG28 [axis], the homing state of the respective axis is cleared even before...
Thanks, that was the missing link.
No the conditional G-code is here in RRF3.01(rc11) I want to check if a tool is on the carriage before homing Z. But I can't figure out what the...
That's certainly a possibility. But you can't use it for bed leveling (G29) in that case. Yes, that would be nice :)
Currently, there are three points that keep me from ordering a Nimble: I wonder why Zesty doesn't use a dual hobbed gear - the basic design with...
Please, please go ahead and order it. We're all relying on you to make the comparison. :)
Is anybody using differential height sensor (sold by Duet and E3D) with the ToolChanger? How does it compare to the standard switch in terms of...
