Recent Content by Ben Norton

  1. Ben Norton
    Post

    E3D ToolChanger - Z positioning Issues

    Hi Jonas Awesome, thanks for the reply.
    Post by: Ben Norton, Jun 10, 2020 in forum: Tool heads & ToolChanger
  2. Ben Norton
    Post

    E3D ToolChanger - Z positioning Issues

    That's very interesting, let me know if you can remember any more of the details. At the moment the tool changes seem reliable at C position...
    Post by: Ben Norton, Jun 9, 2020 in forum: Tool heads & ToolChanger
  3. Ben Norton
    Post

    E3D ToolChanger - Z positioning Issues

    Hi @Nibbels I found the time to update my firmware to RRF3 and it all went relatively smoothly. I used your sys files as a guide and implemented...
    Post by: Ben Norton, Jun 8, 2020 in forum: Tool heads & ToolChanger
  4. Ben Norton
    Post

    E3D ToolChanger - Z positioning Issues

    Hi Krayn That would be amazing, thank you. Let me know if you have any luck. Nibbels - Thank you for your suggestion and the link to the useful...
    Post by: Ben Norton, Jun 2, 2020 in forum: Tool heads & ToolChanger
  5. Ben Norton
    Post

    E3D ToolChanger - Z positioning Issues

    Hello Krayn Thank you again for your reply. That would be amazing if you could do some investigation on those changes in your config if you can...
    Post by: Ben Norton, May 28, 2020 in forum: Tool heads & ToolChanger
  6. Ben Norton
    Post

    E3D ToolChanger - Z positioning Issues

    Hello All Thank you all for your reply. @Greg Holloway - I have updated the firmware to the lastest Rev 2 (2.05.1) but with no changes to my...
    Post by: Ben Norton, May 27, 2020 in forum: Tool heads & ToolChanger
  7. Ben Norton
    Thread

    E3D ToolChanger - Z positioning Issues

    Hello All I have been working on my Toolchanger for a little while now and I have always had an issue with the Z positioning during a print. I...
    Thread by: Ben Norton, May 26, 2020, 21 replies, in forum: Tool heads & ToolChanger