Separate names with a comma.
I forgot to speak about that... I put some thermal compound too, it made things better :-)
Extruder motor: 17HS6002-N27B Extruder stepper driver: RAPS128 Extruder stepper driver Vref: 1.367v (1.24A) Extruder steps/mm: 404 Extruder...
You could be sure of that if you're running Repetier Firmware, on a EEprom-ed controller. When sending new firmware with arduino IDE, you also...
I had lot of jammings when my heatsink fan was not full powered 100% of the time. It should be connected to direct 12v supply (or 24v according...
If you want the real real deal, don't think you're buying genuine e3d when you pay it $7.
Can you measure how much voltage is supplied by your PSU ? Is is titan extruder ? how much microsteppings ? Which controller board ? Which...
Fine oil is pretty good option for this purpose, even if my point of view is no oil at all
My hotbed is onyx bed from rostock max (seemecnc), it's very difficult to drive it to 80° with 12v, so i'm converting it under 24v Just tried...
Maybe eeprom setting inside firmware, preventing from overwriting parameters you send. Ever seen with a melzi board.
Maybe your stepper is too weak so you have to help it You could try following values, just to see if there is any improvement MAX_FEEDRATE of 40...
I have experience with 1spool of Edge filament, and now experiencing with Colorfabb nGen, T° glass are similar, inter layer bonding seems to be...
Yeah, that's exactly why you sometimes hear about so much trouble with bowden settings on forums, there is less control on what you actually do,...
1/8 should be minimum microstepping for extruder, you have another issue. Is any version of repetier firmware ? How do you change parameters ?...
There is no rule with retractation, it depends on : -bowden lenght, -bowden actual inner diameter -filament diameter. -filament stiffness -any...
Yep agree'd, you don't look for any resolution, you look for a lot of torque ;) 40mm/s should be the minimum retract speed with bowden tube, I...