Recent Content by Cem Eraslan

Thread
Hemera under extruding after few layers.

Hello, My filament is Amazon basics PLA. Hotend is 215 degrees bed is 60 degrees, Retraction is 1.6mm. I am printing through octoprint. Board is...

Thread by: Cem Eraslan, Nov 29, 2020, 1 replies, in forum: HotEnds & Extruders
Thread
Hemera under extruding after few layers.

Hello, My filament is Amazon basics PLA. Hotend is 215 degrees bed is 60 degrees, Retraction is 1.6mm. I am printing through octoprint. Board is...

Thread by: Cem Eraslan, Nov 29, 2020, 5 replies, in forum: HotEnds & Extruders
Post
Hemera Stops Extruding

I am literally tired of this product. I bought this product to achieve consistency. But now it is one of my black holes.I bought it, I had many...

Post by: Cem Eraslan, Nov 16, 2020 in forum: Troubleshooting