Recent Content by Chris Emory

  1. Chris Emory
    Post

    Nozzle X - extra stringy....?

    I went too far with flawlessly. Big pieces with low detail were flawless. Smaller pieces with higher detail and supports are far from flawless....
    Post by: Chris Emory, Jan 22, 2020 in forum: Nozzles: sizes; materials; swapping.
  2. Chris Emory
    Post

    Nozzle X - extra stringy....?

    I can not explain it but I decided to try the Nozzle X again, made no changes at all from the settings I was using with the brass nozzle, and it...
    Post by: Chris Emory, Jan 1, 2020 in forum: Nozzles: sizes; materials; swapping.
  3. Chris Emory
    Post

    Nozzle X - extra stringy....?

    I tried a range of different temps up to 250. Using PETG btw, and also tried 3 different rolls.
    Post by: Chris Emory, Dec 23, 2019 in forum: Nozzles: sizes; materials; swapping.
  4. Chris Emory
    Post

    Nozzle X - extra stringy....?

    I purchased a Nozzle-X a few weeks ago and never could get the filament to lay down. Went through an entire roll changing everything I could think...
    Post by: Chris Emory, Dec 17, 2019 in forum: Nozzles: sizes; materials; swapping.