Separate names with a comma.
Ok, I'll check them. Thanks
The printer ist one of the first batches from the Kickstarter campaign and I didn't change anything on the FW, so its the original. I also thought...
Sounds great, bitte I'm afraid of crashing the Board. I haven't done that before. Is there anything that can go wrong? Have you ever done that...
No, I didn't change anything on the FW
Its a BigBox with the standard Glassplate which was shipped with the printer.
Hi, when I manually Level the Bed, I can pull a peace of paper slightly between the Nozzle and the Bed in the left and the right handside. If I...
@K3LAG The Led is only in, when the bed approaches. @R Design I've calibrate them correctly yes. After a few more trial and errors, I figuered...
Oh, I forgot to mention this. I did store the memory.
I made the following steps: Loosen the IR-Sensor and move it down, so its slighly under the nozzle. Config Z-Offset to -5 mm. Doing Auto-Home....
Hi, I'm totally new to 3D-Printing and the BigBox is my first 3D-Printer. Now I'm stuck at the point of calibrating the Z Offset. I've follow the...