Recent Content by Craig

  1. Craig
    Post

    Upgrading Prusa MK3

    Thanks for the imput. Would you happen to know if the Prusa MK3 could handle a 30w or 40w heater cartridge? I assume to use those id need a...
    Post by: Craig, Sep 12, 2018 in forum: Build Help
  2. Craig
    Post

    Upgrading Prusa MK3

    that helps very much, thank you. is the 30w or 40w worthwhile to get? would that help me achieve faster speeds, or better quality prints with a...
    Post by: Craig, Sep 11, 2018 in forum: Build Help
  3. Craig
    Post

    Upgrading Prusa MK3

    Its just the stock Prusa MK3, was hoping someone here had experience with this combination. guess i better go post on the prusa forums as well :)
    Post by: Craig, Sep 10, 2018 in forum: Build Help
  4. Craig
    Thread

    Upgrading Prusa MK3

    I'm planning on upgrading my Prusa MK3 to a Volcano hot end. The Starter kit/Eruption Pack comes with a Thermistor and Heater Cartridge, are these...
    Thread by: Craig, Sep 10, 2018, 8 replies, in forum: Build Help