Separate names with a comma.
It may be that you have faulty gears, please contact support@e3d-online.com for help getting your system up and running.
Can you remove the antibacklash nuts? and see if the problem goes away, just use standard POM nuts.
For all enquires regarding replacement parts or refunds, please contact support@e3d-online.com. We are able to respond to tickets at a faster rate...
Unfortunately, we do not have any slicer profiles available.
Hi Benno, Can you post some images of your setup?
205 for PLA, it would be better to run a temperature calibration tower, as every filament manufacturer requires slightly different settings.
I agree with Danny, it's very difficult to assess issues people are having based on forum discussions, we often find that people jump on the...
Thermal paste is not an optional step it ensures heat transfer from the heatbreak to the heatsink is effective. Heatcreep would be the result of...
Have you used thermal paste on the heat break?
V6's ship with a 0.4mm nozzle, I would suggest doing a cold pull to make sure your nozzle is clean. What temperature are you printing at? and does...
Hi Emin, Most of the benefits of Hemera are related to the Direct-drive version. If you use Capricorn tubing (that isn't too long) you will be...
Yeah, overhangs are an issue. As you print faster the part cooling needs to also increase TPU's tend to warp quite a bit if they aren't cooled...
Hi Emin, Sorry to hear you are having issues with Sainsmart, we decided to order some clear Sainsmart TPU so we could do some testing to see if...
Hi Mitch, it sounds like you have the motor wired incorrectly, try switching the middle two wires on the board connection side of the motor...
Hi Rodolfo, I would recommend checking the health of the bearings. Are they still rotating freely?
