Separate names with a comma.
Hi, I have a similar issue. I am running a volcano, I used a retraction setting of 7mm and an extra restart of -0.5mm. This is severe overkill,...
So what could cause me to have to us 0.55mm instead of 0.6mm? Same width, same everything. Over extrudes with 0.6mm, correct extrusion at 0.55mm....
It is technically not over extruding in the sense of steps/mm because the stepper is calibrated properly. It is over extruding because the math...
Hello, I am running E3D bowden with a bondtech QR. I am using the 0.6mm nominal nozzles supplied to me by E3D, I bought separate. If I put...