dc42's Recent Activity

  1. dc42 replied to the thread Hemera extruder with Duet 3 Tool Board.

    I adjusted the V6 PCF duct and the dock bracket to have 4mm thick feet. Now the Hemera tool fits flush against the dock. STLs for the...

    Feb 23, 2020 at 3:11 PM
  2. dc42 replied to the thread Hemera extruder with Duet 3 Tool Board.

    An important note: the fan outputs on the Tool board are 12V only. So assuming a 24V PSU, you need a Hemera with 24V heater cartridge...

    Feb 22, 2020 at 7:27 PM
  3. dc42 replied to the thread Duet 3 Tool Boards are imminent!.

    See https://forum.e3d-online.com/threads/hemera-extruder-with-duet-3-tool-board.3638/ for my build of the Hemera tool with tool board.

    Feb 22, 2020 at 5:12 PM
  4. dc42 posted a new thread.

    Hemera extruder with Duet 3 Tool Board

    I've finished assembling it. Here it is: [ATTACH] I used Greg's design at https://www.thingiverse.com/thing:4008778 except that I had...

    Hemera tool with tool board.jpg

    Forum: Tool heads & ToolChanger

    Feb 22, 2020 at 5:06 PM
  5. dc42 replied to the thread Duet 3 Tool Boards are imminent!.

    No, but the 16-bit ADC on the tool board is great for PT1000 sensors, which E3D now sells....

    Feb 21, 2020
  6. dc42 replied to the thread Duet 3 Tool Boards are imminent!.

    Not quite, because the feet (the bits that screw into the side of the motor) of the PCF duct are thicker (6.1mm in my printed part) than...

    Feb 21, 2020