Separate names with a comma.
If your slicer doesn't command the correct Z position after it commands a tool change then you need to add a command to the end of your tpost#.g...
Are you saying that the value in the status window is updated for some values of Z in that G10 command but not for others? Did you have that tool...
I've found two videos that have plausible explanation of two different causes of VFAs. This one: [MEDIA] explains how VFAs with a large pitch can...
Paul, can you tell me what you don't like about Duet Web Control, what you particularly like about the Klipper web UI and which one you are using...
I switched to the 6HC because I wanted to use tool boards. The tool boards are mounted on the Hemera hot ends. See...
You can find the configuration files that I used on my TC (before I upgraded it to a 6HC + tool boards) at...
I have a Mandela Rose Works magnetic bed and a Wham Bam flex build plate that fits it. I removed the glass bed from the tool changer and screwed...
Your M571 commands look OK to me, however your firmware is out of date. The current stable version is 3.4.5. You say the it is a non-extrusion...
I'll report your problem using the Duet3D forum with the appropriate manager. Meanwhile, please try making another post on the forum. A short one...
I haven't added endstop switches to mine, however it should be straightforward. Use the normally-closed contacts of ordinary microswitches,...
Hi, I'm sorry to hear that your posts on the Duet3D forum are being flagged as spam. To avoid that happening: - Verify your email address after...
Perhaps you just need to increase the movement speeds in the tool change files?
I'm not familiar with the BigBox, however when I had problems with a Titan extruder I replaced it with a Bondtech BMX, which I found much more...
You might find this page from my blog useful...
The blowers I am using are 12V Winsinn ones, because I use tool boards on the Hemera tools and the original version of the Duet3D tool board only...
