Separate names with a comma.
Meanwell is the brand I also use. They are getting hard to find because so many are being bought up for 3D applications. Have a great printer!
http://www.ebay.com/itm/HP-6268B-DC-POW ... 41905630a1 http://www.ebay.com/itm/Mean-Well-MW-Sw ... 121020%26m
One possibility....http://www.ebay.com/itm/HP-6268B-DC-POW ... 41905630a1
The 24Volts would normally connect to the Heated Bed via an SSR. The 24Volts would also connect to a 12V converter that would feed the Rambo and...
Most heater beds are rated at 12V but a lot of people run them through a solid state Relay and use 24V, the 24V power supply Attaches to the...
I can assure you that the Cyclops and Chimeras will be added to the forum as soon as Josh or Sanjay have the time.
You are welcome and good luck!
As long as the extruder fits the E3D I see no problem on using it with a direct extruder. If the connection to the extruder is loose you can...
Have you tried to remove the bowden fittings at the top and mounting it?
At the bottom of the screen at e3d-online.com you will see a contact button. Press it and a form opens up for you to fill in. This is the...
Most Kraken users on SeeMeCNC.com forum are using an ABS mount and have no problems with the plastic getting to hot.
May I ask who the manufacturer of the filament is, or is this an Ebay no name?
Honestly, it sounds like you have a defective roll of filament.
I would try turning the temperature down about 5C.
You sent a message to the support email address and it was ignored? That has not been my experience.