Separate names with a comma.
Just an update. I installed the stock CR10S Heater Cartridge (12v 30W) and the heating is now stable. [ATTACH] Br, ET
Hello Daniel, I have opened a support ticket but no response yet. Br, ET
I just measured the resistance on the heater cartridge and its at 7.7Ω. Surely this should be lower for a 12v cartridge of 30W, should be like...
Ripped out the power supply, and found an old ATX connected the board to 12v and started printing. So far the temps are as shown in the graph,...
Yup temps were ok before, even when I changed for a microswiss hotend. Despite the capacitor would inadequate airflow over the mainboard cause...
[ATTACH] And the logs: MobaXterm_192.168.10.78_20200109_172915.txt Regards, ET
Incrementing Nozzle temps: [ATTACH] I will enable serial.log and do this again and upload the log
Hello all, Just recently installed the Hemera on my CR10S. Followed all instructions as stated. And now I am getting the following while...