Recent Content by enggmaug

  1. enggmaug
    Post

    Lubricating Kraken Heat Breaks

    I finally took my 3 remaining heat breaks, one after the other, and set them up on my dremel in order to evenly reduce their diameter on 1000...
    Post by: enggmaug, Mar 29, 2014 in forum: Multi-Extrusion
  2. enggmaug
    Post

    Lubricating Kraken Heat Breaks

    Ok, it came out.... but it was not all so smooth and easy. Do you guys think I could exchange my block, 'cause I really believe it's too tight. I...
    Post by: enggmaug, Mar 27, 2014 in forum: Multi-Extrusion
  3. enggmaug
    Post

    Lubricating Kraken Heat Breaks

    Thanks for the tip. Well, I did not use neither a drill press nor a drill bit, but I have a 5mm rod here, that fits just fine. to push on the...
    Post by: enggmaug, Mar 27, 2014 in forum: Multi-Extrusion
  4. enggmaug
    Post

    Lubricating Kraken Heat Breaks

    I have a problem here. I used steel wool, but apprently it was not enough. one of my heat break was stuck there. I tried to turn it using a bolt...
    Post by: enggmaug, Mar 27, 2014 in forum: Multi-Extrusion
  5. enggmaug
    Post

    Lubricating Kraken Heat Breaks

    anyway, some particles remain from inserting/removing the heat break... I know, I cleaned the bloc with coton bud... But anyway, I'll run...
    Post by: enggmaug, Mar 21, 2014 in forum: Multi-Extrusion
  6. enggmaug
    Post

    Kraken CAD Model

    Thank you mkelly. I already used your model to validate my Rostock Magnetic arms Effector for Kraken. It helped a lot. I'll have some...
    Post by: enggmaug, Mar 21, 2014 in forum: Multi-Extrusion
  7. enggmaug
    Post

    Lubricating Kraken Heat Breaks

    Yep, I experienced that just yesterday. As I am installing heating cartridges and thermistors, I put the heat breaks in the main bloc. It was...
    Post by: enggmaug, Mar 21, 2014 in forum: Multi-Extrusion