Separate names with a comma.
Sorry fixed. The branch must set up to Hybrid Dual. Then it writes the config changes. Ready for a first test print.
Try to print a PPSU Filament on Bigbox Hybrid. Needs 380 C to print. On Original FW 1.1.0 RC6 get a MAXTEMP Error at 300 C. So i made a copy of...
Sorry i have not seen that you attached the stl file. The wand is only 0.4mm ! You use Siplify 3d? For the slicer software it is to small. Simpify...
Print an ABS 3mm you need more temperature. Most ABS prints good with 250 C @ 40mm/s At 60mm/s use 255-260 C. With a 0.8mm nozzle 0.4mm layer...
Here it is https://www.youmagine.com/designs/e3d-volcano-silicone-casting-mold Have not tested it if it works.