Separate names with a comma.
Well i think this is my 1st fail point.
Stopped mid print. Now i cant get my hot end to temp. :(
i did that and it seems to keep one height but so far only printed from pc is there steps online to update the pi?
i am at 1.1.0 is that the one or are you talking about 1.2.0 https://github.com/MarlinFirmware/Marlin/wiki?
also i dont know if i said that i...
if do a auto home and a bed Level it changes my Z offset i have moved this offset so much now i cant even say where it should be but it...
I know the 1st layer is hard to get but I am using a 10MM X 10 MM X 10MM. I was thinking there was a problem with slic3r so I moved to Simplify3D...
Email me a box. Please!
It's like it just stops and makes a hole in the boat.
It will complete the print just has a hole. I don't know if it can bridge yet I...
Found the problem! It was me.
The End stop Switch was in the wrong place in the rumba it was X max not X min
Auto home not working the X travils in the direction toward the side that has no switch and I shut it down.
Well I flipped x for y and it's still in the X not the cables. Got to be a setting in the card or a bad rumba.
ok going to prepare, then move axis, move 1mm,
Now if I pick x I move +oo8.0 when I rotate it back to zero I have no movement back.
If I do the...