Recent Content by Gianmarco Baldini

Post

I did. I flashed my firmware with https://dl.dropboxusercontent.com/u/54348751/RC4-hybrid.zip Is there any newer version? Where to put the .hex...

Post

Thanks! Sorry for not knowing, but what to do with those two files? Where to put them?

Post

Yes

Post

Hi Alex, thanks! You solved my problem! Zsteps were wrong. I was using Hybrid RC4 firmware. Now I have another. It seams my X coordinates are...

Thread

I just upgraded my PRO to Hybrid, it seams to be OK, but: Z axis movement is too little. It moves slowly and not enough. When I give command to...

Thread by: Gianmarco Baldini, May 31, 2016, 11 replies, in forum: Calibration, Help, and Troubleshooting

Post

Hi Henry, Did you find the answer to your question? I wanted the same thing. Regards Gianmarco

Post by: Gianmarco Baldini, May 30, 2016 in forum: BigBox General Chat

Post

My bad, I swapped z and y motors. Probably it happens when you assemble printer at 3am. My apologies for taking your time, and many thanks. You...

Post

My bad, I swapped z and y motors. Probably it happens when you assemble printer at 3am. My apologies for taking your time, and many thanks. You...

Post by: Gianmarco Baldini, Mar 5, 2016 in forum: BigBox General Chat

Thread

Hello, I have a problem that I tried to solve through Shoutbox. No luck so I am pasting our conversation here. Please help. Hi, when autoleveling...

Thread by: Gianmarco Baldini, Mar 5, 2016, 3 replies, in forum: Calibration, Help, and Troubleshooting

Thread

Hello, I have a problem that I tried to solve through Shoutbox. No luck so I am pasting our conversation here. Please help. Hi, when autoleveling...

Thread by: Gianmarco Baldini, Mar 5, 2016, 2 replies, in forum: BigBox General Chat