Separate names with a comma.
Thinking of getting this set up also, any like step by step how to install the accelerometer, does it need to be on each tool or on the toll...
Would´t it be possible to have the spool directly on the rear wall beneath the extruder. The clearance is 10mm less then on the side but with a...
What about a kit with hemera instead of the v6 bowden. I suppose all the not fulfilled pre-orders might want to get the hemera. Since I only...
I have only bought 2x V6 Bowden Tool 1.75mm and now planing on getting the hemera. Can the tool dock assembly + the TC Receiver be bought without...
The z was zeroed out. I run without glass plate first and then noticed that after last point probing it went to z x and crashed into the end...
So I reinstalled sd card. And tried to run g29 s1 but got an error that the heightmatp.csv was not found. So hit the autobed compensation button...
I am just running it from the web interface.
When running the bed mesh leveling there is something strange at the end. It runs through and checks z at points defined, but when done it crashes...