Separate names with a comma.
All you do for IDEX is use the Xmax Endstop for the right extruder, and E2 for the right X motor. I have both part cooling fans connected together...
This is what you need:
I am sure it is possible I did run cura with one extruder only, and bcn3d sigma uses cura with Idex so all configurations are possible under cura,...
Full metal 3030 Idex bigbox with linear rails and direct titans.
Printed at 100micron with matteforge pla gray.
I have the buildtak flex plate system on a FLAT cast aluminum bed and I still have some issues, I believe that the buildtak base with the embedded...
I have seen printers flipped upside down to eliminate sagging... crazy!
I believe that the idea is to extrude slowly and with the most fan to cool the material “in place” before it saggs while bridging.
Those will only work with the 1010 makerbeam and nema 14 motors.
So unless you have that they are no good for you.
[IMG] Here is an image to see how they go together.
I know, it gets pretty tight in there.
Keep in mind that i have the linear rail attached to a 1010 makerbeam extrusion but it will work if you...
Don’t tell me you gave up on it. I did it and it runs like a charm![IMG]