Separate names with a comma.
After you read that and made sure all is tight and true. Then you need to mechanically level the bed. This ensure the XY gantry is as parallel to...
Yes, you are right... Got my hopes up... This is the reason NOT to continue on the BB. The really good users (that contributes) are getting...
Yes, I agree that if you would upgrade anyway you can keep tinker with BB. Gonzalo: I'v been looking for exactly that upgrade to the XY-gantry....
Only downside with this one I found is that E3D do not officially support the printer for their new products. I.e mounting kits in the shop... I...
Any progress? Just bought a few parts in E3D's store that I think I need to make this so I hope that you have a successful upgrade running by...
It looks like the one I have (not the same color though) There is a lot of possible small upgrades that improves print quality. Seems to be a...
Inspried by this... making a roller bearing (605zz) version for th 8mm rods to test... not sure if I need it though after looking at yours after...
The new design for the tool change system is more or less exactly what I tried to explain here... Except for I did not look for a tool change...
If this was just offered as a X/Y mod kit for the BB that would be nice... 2 two head version maybe... Then I would have jumped on this... this...
Nice, an absolute truth where there is no wiggle room for interpretation ;) I use the plastic nuts... if they wears out I exchange them so no...
Oh yes... that issue... Do you have the thruhole version of the IR sensor? Do you IR part look like this?:[IMG] I straiten mine but was not...
Yes, I do not like the sag. I'd like to really be able to trust in the assumption that the bed is flat and all that is needed is a simple end...
Since there was a size question and that I yesterday mounted my duex I was thinking about the possibility to have 2 smaller steppers on the y...
I'm also interested... Made a thread asking if anybody was looking into upgrading the Y axis... The problem today is the number of variants is...
Dual extrusion is my setup... So not possible as is. So I need to buy the expansion board. Ok then the decision is easier... The print...
