Separate names with a comma.
Oh that would help! It is MakerGeeks PLA.
Update. I checked the connections. I am actually getting a LOW reading on the main nozzle. My bed and left nozzle are at 24C and the right is at...
I finally got my first successful print without the filament grinding down and ultimately jamming. However, while it completed. It has a few...
I did cut it to the exact length of 83mm (twice actually since I thought the first one was too short but it ended up being the same). Can you by...
I have been trying to solve an issue of all my prints failing due to the filament grinding, and this has been something I have been wondering. Not...
I've got another thing happening now too, where the left nozzle temperature shoots up to the 280s and I get a MAXTEMP error, when the entire...
Sorry this is 1.1 Dual Hybrid. Firmware version is whatever came stock, (received early July) I'd have to confirm that later. Yes it is a constant...
Right after powering on from idle, my left nozzle is 30 degrees C higher then the right. Is this a broken/shoddy part, or is there something else...
Looks like I just confused a lot of the wiring, I switched it around and it works now! If I did it all again I'd add labels to the ends of each...
Anyone? To maybe further clarify, the temps and heaters do seem to work properly. When I tell extruder 1 to heat to 210 the right nozzle does heat...
So I managed to get a test print started on my BB Hybrid Dual Titan (kind of) except my extruders are backwards. I thought maybe the motors were...