Separate names with a comma.
Is anyone willing to share the duet config that includes BLTouch?
running duetwifi, duex5 and pt100 daughter board.
@gonzalo How do you wire the x motors (as there are now 2)? Similar to how the z is wired?
Hi can anyone help me with a pic of wiring on the rumba for IDEX?
I am building Greg's aero IDEX with linear rail.
Hi Guys! is there anyone running this on rumba that can help me with wiring and getting it up and running?
Can you send a pic of your rumba?
Which Molex did you use for your build?
After a long pause, I am trying to get this up and running. Are you still running this linear rail version on rumba? Is there any...
Finally grabbed the rest of my parts for this from e3d. printed and all the bits from Gregs thingiverse.
I ordered bltouch and the updated...
Thank you @Rob Heinzonly ! 40mm x 40mm x 20mm?
Most of the listing I see are 50mm
will these work?...
I have all my parts with the exception of the print cooling fan. What in the world are those fans called? Where can I order them from?
Thank you guys so much.. @Folkert Kaman I will give this a shot with the rumba first as I really like octoprint and the camera.
If I end up...
I have printed all of the 3d printed parts and the last of the additional bits should be here Monday.
Can I make this work with rumba w/ pi and...
I will investigate a bit further once I get some prints out of the way and let you know what I find.
@Greg Holloway Yes, I did take the cables out and give them a once over. and the connectors on the stepper motor side seem to be fitting snug and...
yes it is .59 - .6 someone suggested i try .5
I have checked all the wiring.