Separate names with a comma.
@Greg Holloway - Yes right side extruder, The picture labeled RS Ext in my previous post shows the part I made (Print Fan Bracket) out of the gray...
@Greg Holloway - Thank You. Is there any way in the meantime to test PT100 amplifiers as a double check? I was pretty sure I wired everything up...
@Greg Holloway - I hope one of these will works. They were on my phone from last night, and I am at work now and wont be able to get one until...
I have went through everything again. I even checked the resistance at the connection to the PT100 amplifier to make sure the connection was good...
@Chase.Wichert - just nothing at all. @Greg Holloway - I will go through wiring again. As I stated above I am getting voltage readout at the...
If your hotends still measure then it seems less like a wiring problem since all mine went to zero at once after over a week of printing. Any idea...
Sure. What areas are you looking to see? If one wire was bad would all 3 temp read outs be at 0 on the LCD screen?
Hi Greg, I meant that there is still no communication. Forgot that little word.
Hi Greg, I have tried reconnecting and checking all possible wires and connection points all weekend. If one was bad would all 3 read 0 on the...
I tried to connect the board and there is no communication. I have a dual and have tried connecting with the RJ45 and removing the fan panel to...
Thanks, just read the post. I have checked the resistance of the or the PT100 and both are reading 107.5 ohm's. I have checked to make sure...
My BigBox has a Err: MAXTEMP. I have been printing for a few days and now this is on the screen and I can nod functionally do anything. Any Ideas?
