Separate names with a comma.
Thank you both for your answers and advice. The PTFE tube did the trick I am now able to print and load with TPU.
I see it now in the manual. Mine came partially assembled so I assumed it was done correctly. How much would you suggest chamferring ?
I see it now. I did not put pfte inside, I misunderstood and thought the filament guides eliminated that. Thank you for the info
My mistake, the pieces I am referring to are included with the v6 hot and goes ontop of the heatsink end to eliminate the need for the pthe tube...
Mark, I tried that. I can push it as far as the heatbreak. Then it stops. It will not extrude passed that either. Perhaps I have the fan upside...
Thanks, but did not work. Tried varying levels of thin. It seems it gets clogged in the hot end but never gets to the nozzle. With the nozzle off...
Thank you, I will try this out.
My titan has the new plastic filament guides. no ptfe. I am unable to push the filament to the bottom as it gets stuck before getting to the nozzle.
Good evening. I upgraded my Maker Select v2 to Ramps 1.4 Marlin1.1.0 RC8 with BLTOUCH and Titan/E3d. I have yet to get a successful print... but,...