Separate names with a comma.
Im setting up linear advance on my direct drive Hemera on a Tevo Flash, ive done the test prints and .06 seems to be spot on. Do I need to do...
E3D are out of stock on the 24 volt fan for the E3D Hemera but have the 24 volt 40x40x10mm fan comes as standard with the Titan Aero in stock, is...
I have the black wire going to the left pin on my Tevo Flash with the MKS GEN L board, I asked on the Facebook group and they said if it wont...
I gave it a service when I fitted the Hemera and fitted some new wheels on the x carriage and everything was running smoothly and tight. Now 1...
The nozzle is the .4mm that came with the Hemera and usually .2mm layer height and 40mm/s print speed and 90mm/s travel. Slicer is Cura 4.5.0 I...
One thing ive noticed when its retracting is the lever moves towards the front, like it you were releasing pressure to remove the filament, its...
Ive had the Hemera on my Tevo Flash with 2100 drivers for 3 months and struggling to get decent quality prints. VREF set to 1.19 and I also set it...