Separate names with a comma.
I tried this build and prints started layer shifting on the Y axis. Same same gcode would shift at different layers but always only in Y. I went...
Dichloromethane has been banned in paint strippers in Europe since 2009. If you have any nitromors older than that it’ll still have it in.
I ordered using Greggs affiliate link and delivery was 2 weeks, YMMV
Weird. And presumably sudden. Bad connection?
I plan to include a BLTouch mount for v6 and volcano for mine. The Rail is here, the Ends and quick swap extuder mount are printed, I just have to...
Did you loctite all the grub screws on the pulleys?
Yes I've ordered the rails and printed the parts. I'm going to build it as a single extruder solution first rather than idex and I've modified...
There's also a new setting called "Suport Base Layers" in the support tab which puts solid layers under your supports. Its a big help too. Just...
Could be almost anything; Faulty stepper Low voltage Wrong heater Bad assembly User error
It can be done but it's a matter of effort:reward compared to replacing it.
check the time it takes to slow down and stop when printing and then extrude filament into the air for the same or more and see if it does the...
If the heat block is tight against that washer in image 3247 that's going to transfer even more heat into the cooling fins.
My biggest issue was actually getting the pei for a reasonable price. Rich Rap mentioned this source in the U.K. http://www.andornot.co.uk/
That looks very similar to the hotend posted by another new user in another thread...
If I had to guess I'd say it's because of multithreading causing calculations to be resolved and returned in different orders. I don't see why...
