Separate names with a comma.
Re: Lubrication on the Kraken So i received my Kraken yesterday and while assembling it i had the exact same thought. I applied a little High...
Much appreciated. Its a new printer that is modular allowing you to increase the build volume with simple hardware increases ie: Rods and belts.
Well i just ordered a RigidBot printer to try it out on. I know the controller included will support at least two hot ends/extruders, but i'm...
Awesome, I wasnt sure if there were any available for purchase or if you just print one and attach it to a stepper motor. Thank you.
At risk of sounding like a noob (i am to bowden at least), what are people using for extruders to the Kraken? I have a printer with direct feed,...
