Recent Content by kpreuss

  1. kpreuss
    Post

    Heat creep/clogs

    Final Update. Make sure to use the right nozzle and that the lower heat sink fan does not touch the heat block Make sure your wiring is good....
    Post by: kpreuss, May 23, 2020 in forum: HotEnds & Extruders
  2. kpreuss
    Post

    Heat creep/clogs

    I am about to do another test tonight. Baby Yoda with tree supports following the same recipe as the last benchy. But I am going to make the...
    Post by: kpreuss, May 22, 2020 in forum: HotEnds & Extruders
  3. kpreuss
    Post

    Heat creep/clogs

    I thought I would share with you some quick note with some Benchy's BTW, after I figured out the nozzle issue. I then found that when my print...
    Post by: kpreuss, May 22, 2020 in forum: HotEnds & Extruders
  4. kpreuss
    Post

    Heat creep/clogs

    I thought I would update. No Paste yet but it is coming tomorrow. Yay. However, I have it running a Benchy without clog yet. Here is my...
    Post by: kpreuss, May 20, 2020 in forum: HotEnds & Extruders
  5. kpreuss
    Post

    Heat creep/clogs

    I was looking into that late last night, and I read the thermal paste for CPUs is not good for this application. Temperature ranges was the...
    Post by: kpreuss, May 18, 2020 in forum: HotEnds & Extruders
  6. kpreuss
    Post

    Heat creep/clogs

    I bought a genuine E3D V6 2 weeks ago and have only completed 1 print of 20 or so. I did not use thermal paste as my package did not come with...
    Post by: kpreuss, May 18, 2020 in forum: HotEnds & Extruders