Separate names with a comma.
All good info- Not sure if I mentioned it before but when I tried to use SpreadCylce the prints were just as bad if not worse. However I only...
I guess I have to slightly disagree there. I understand what you are implying however I don't think the Hemera is so precise the extrusions are...
Thank you for chiming in - I will have to look over the information you linked. I have tried turning off stealth chop on the extruder and there...
Well I have went through all I can think of to fix the issue. Seems like the Hermes / Hemera is not going to produce print quality that some other...
Gato I noticed in your config you turned off stealth chop for the extruder. I have left mine active. Did you see improved print quality on the...
The Good: Well I have successfully swapped the board over to the SKR 1.4 Turbo and slashed my way through making the firmware in Marlin 2.0 for...
Sort of what I was thinking but hoping not. I ordered a SKR 1.4 board / TMC 2209 drivers just hope I can figure out the firmware. :) I am a...
The mini rambo board only have A4982 drivers. I don't think stealth chop is an option for this board. It's max is 16x micro stepping not many...
I do not doubt that swapping drivers would help;unfortunately unless I change the board out , which I am thinking about doing, I don't have a way...
Video and some more pics of things. Did a temp tower at the moment but I will do something different and make a small video of that as well once...
First off thank you for all the help and trying to decipher the possible issues. I honestly appreciate it. Now onto the list! 1- I really can't...
In regards to the change in the print , that was just temps and speed. I was playing with cold vs. hot at different speeds. Not really much change...
Well definitely not the daughter driver board. I swapped the steppers back to the mini Rambo taking the daughter board out of the equation. It did...
I've tried so much at this point I have forgotten where I started and what I've done lol. Short answer is no I never did resolve the uneven...
https://drive.google.com/folderview?id=10-EKAV6_48PUKxXClPZhZJ6PpL7r2iiN
