Recent Content by KRavEN

  1. KRavEN
    Post

    E3D Edge Grey45 1.75mm very brittle

    Thanks for the info Tim. As always support from Filastruder is top notch. The spool was vacuum sealed when I opened it so no chance it could...
    Post by: KRavEN, Jan 9, 2017 in forum: Filament
  2. KRavEN
    Post

    E3D Edge Grey45 1.75mm very brittle

    I want to add that the roll came out of a sealed box and it was in it's sealed wrapper with desiccant inside. I loaded it immediately after...
    Post by: KRavEN, Jan 6, 2017 in forum: Filament
  3. KRavEN
    Thread

    E3D Edge Grey45 1.75mm very brittle

    Just did my first couple of prints from a roll I got from Filastruder. The parts are very brittle. I can easily break a fairly sizeable...
    Thread by: KRavEN, Jan 5, 2017, 4 replies, in forum: Filament
  4. KRavEN
    Post

    Drag Chain Size

    So 7mm x 7.3mm then?
    Post by: KRavEN, Jul 7, 2016 in forum: Build Help
  5. KRavEN
    Thread

    Drag Chain Size

    The BOM lists only 400mm length x 2 for the drag chain. What are the dimensions of the links? 15mm x15mm or 15mm x 20mm?
    Thread by: KRavEN, Jul 7, 2016, 3 replies, in forum: Build Help
  6. KRavEN
    Post

    COMPLETE BigBox XL (increased Z height)

    I'm almost complete with my mpcnc build so use that to cut it out. I've been thinking of using alumet aluminum composite instead of plywood. I...
    Post by: KRavEN, Jun 17, 2016 in forum: Guides, Mods, and Upgrades
  7. KRavEN
    Post

    COMPLETE BigBox XL (increased Z height)

    We're the files modified for 6mm as well or is the new nut trap all that was needed?
    Post by: KRavEN, Jun 17, 2016 in forum: Guides, Mods, and Upgrades