Separate names with a comma.
Bridge Nylon is one of my favourite materials to print with. Here are the gears for the winder all done. [ATTACH]
Ditto on all your comments.....I realised late last night when I started assembly that its not metric so about to head to my fathers workshop to...
My big box settings is using the Default Pro S3D profile settings with the following changes: Turn off cooling Extruder Temp 250 Bed Temp 45 They...
Here is the Taulman Range of recommended settings. http://taulman3d.com/best-print-settings.html I highly recommend their bridge range of...
I love to print in Nylon and the Taulman range is fantastic. I once did a job for someone for some car roof racks, I was very hesitant but he...
Same problem I had, was wrong motors for me
Yes I found this out some time ago with a cheap set I bought off ebay. So I a set locally and haven't had any problems. Also just back from...
Hey I saw (and backed) them today as well.
Not only should you keep octopi updated, but you should also log into your pi via ssh and keep the OS up-to date via the apt-get commands.,...
Nice work! I haven't tried Ninjaflex on this my Bigbox yet, but on my other printer with a Bowden extruder I print slow with no retractions
Will be interested to see how you go so please post your results
Toms Guide on Tuning these settings https://youtu.be/7HsIZuj9vOs
I remember playing around with all these settings a few years ago to see if I could tune my other printer (a felix V3.0) for faster prints and...
While running a print I touched the motors and was surprised just how hot they were, this was with the Stepper drivers set to the correct voltage...