Separate names with a comma.
Likewise there is definitely nothing obvious (including the umbilical) that is causing this. Might just learn to live with it unless someone else...
Ok I think I know what is causing but not sure how to fix it. When the printer travels to Y=235 at the end of the print it disables the steppers,...
Ok here is the position before the print. [ATTACH] [ATTACH] And here is the position after the print. [ATTACH] [ATTACH] When the print...
Thanks again. Just in case here is my start script - G1 Z10 ; lower bed by 10 mm G1 X95 Y200 F3000 ; dock position G1 X95 Y235 F3000 G92 E0 ;...
Thanks. Here is my end script- M117 Print Complete G1 X95 Y200 F3000 ; dock position G1 X95 Y235 F3000 M104 S0 ; turn off extruder M140 S0 ;...
OK so checked all belts and pulleys and although I did have an issue with one of the belts that has been fixed and it is still not performing...
Thanks I thought about that but it is consistently 5mm off once you start a print each subsequent one prints in exactly the same place
I'm far from an expert but will do my best. As far as I'm aware the IR sensor is purely for homing and levelling the bed so once the print has...
Hi, I have an issue with the y axis. Here is what happened on my last print. I auto homed and levelled the bed. I started a print (the nozzle...
Another update, I had to stop the print. I started it again and am back to square one. This is very frustrating!
Ok so an update, I tried saving the file to the SD card and starting the print from the printer which worked fine. I then deleted the g code from...
I did the hybrid pro calibration (http://wiki.e3d-online.com/wiki/Printer_Commissioning#.284.3.29_Calibrating_Z_Offset) which is the one I did...
Fair enough. Its a hybrid pro titan 1.1.0 RC6 Am using S3D and the profile is the Bigbox Hybrid-pro
Hi, I'm having a strange problem that appears to have started since I had a jam. When I start a print the first layer doesn't happen due to the...