Separate names with a comma.
Thanks!
Heyo humans, I've been tinkering with this awesome tool on my E3D toolchanger. I've so far gotten the tool built, the gcode loading, brushless...
Welp turns out I had to invert the signal for it to work. Odd, I couldn't find any documentation online about that Here's my gcode to get it to...
Thanks! I'm not getting the motor turning but I do see a 50hz output on the duex5 heater 3 (pwm 2). I'm running RFF3 firmware now. Is there any...
I've used the config.g file for setup, connected signal/ground on esc into fan 8 on the duex5, and have been unable to get the motor to respond...
Nice! My total wired up weight of a V6 hotend with an Orbiter extruder was 296 grams