Recent Content by mebrein

  1. mebrein
    Post

    Banding issue on TC/Hemera/Duet2

    I made a typo. The max temp difference is about 0.3 degrees celsius. I now printed at 200 degrees, the min temp was 199.9 and max temp 200.3. Will...
    Post by: mebrein, Jun 8, 2020 in forum: Tool heads & ToolChanger
  2. mebrein
    Thread

    Banding issue on TC/Hemera/Duet2

    [ATTACH] [IMG] I hope someone can point me to a direction to a solution to fix this banding issue I have om my Hemera toolhead with NozzleX...
    Thread by: mebrein, Jun 7, 2020, 3 replies, in forum: Tool heads & ToolChanger
  3. mebrein
    Post

    Noise

    Same over here. I print with 2 Hemera tools, it's hand warm, happy camper. Will watch it coming weeks, especially during summer where the printing...
    Post by: mebrein, Feb 12, 2020 in forum: Motion System
  4. mebrein
    Post

    Noise

    I think it will eventually get too hot.... I even think to mount the PSU on the outside of the box. And design a box around the terminals. Like...
    Post by: mebrein, Jan 10, 2020 in forum: Motion System
  5. mebrein
    Post

    Noise

    To put the money where the mouth is.... I prototyped the following dxf's for the Mean Well UHP-500. So the backplate will be aluminium, between...
    Post by: mebrein, Jan 4, 2020 in forum: Motion System
  6. mebrein
    Post

    Noise

    Well I ordered this Mean Well 500W fanless supply. It needs to be mounted on an alu baseplate for extra cooling. I think I will replace the...
    Post by: mebrein, Jan 2, 2020 in forum: Motion System