Recent Content by Michael Brazda

  1. Michael Brazda
    Post

    Heat creep/clogs

    No
    Post by: Michael Brazda, Feb 15, 2020 in forum: HotEnds & Extruders
  2. Michael Brazda
    Post

    Heat creep/clogs

    Just fyi I am running klipper firmware with the thermistor sensor_type: ATC Semitec 104GT-2
    Post by: Michael Brazda, Feb 12, 2020 in forum: HotEnds & Extruders
  3. Michael Brazda
    Post

    Heat creep/clogs

    I am not running a cooling fan as I am trying to print petg. I tried at various temps as low as 235c and as high as 260c. The only time it seems...
    Post by: Michael Brazda, Feb 12, 2020 in forum: HotEnds & Extruders
  4. Michael Brazda
    Post

    Heat creep/clogs

    what size nozzle do these come with? The nozzle is not labeled but I noticed that manual push there is a lot of resistance. I just swapped the...
    Post by: Michael Brazda, Feb 12, 2020 in forum: HotEnds & Extruders
  5. Michael Brazda
    Post

    Heat creep/clogs

    Yes it is.
    Post by: Michael Brazda, Feb 12, 2020 in forum: HotEnds & Extruders
  6. Michael Brazda
    Post

    Heat creep/clogs

    Post by: Michael Brazda, Feb 12, 2020 in forum: HotEnds & Extruders
  7. Michael Brazda
    Post

    Heat creep/clogs

    I took to sock off for better view
    Post by: Michael Brazda, Feb 12, 2020 in forum: HotEnds & Extruders
  8. Michael Brazda
    Thread

    Heat creep/clogs

    I am completely stumped on my clogging issues. I just purchased a e3d v6 24v. I have assembled it per the instructions. I am currently trying to...
    Thread by: Michael Brazda, Feb 12, 2020, 23 replies, in forum: HotEnds & Extruders