Separate names with a comma.
Just to close this topic: I have connected the amplifier board and I needed to figure out, how to connect the 3 wire output, but now it works...
Antoine, would you disclose what's so special on the Prusa mk3 heatbreak from e3d?
Thank you Antoine. Yes, the wirs are red, so great, it is 40w. Then I will test the PT100 with amplifier board.
... also the heater cartridge I ordered from E3D. So only heatbreak is micro swiss.
I changed the firmware, and according to the firmware you can run PT100 without amploifier, at least there is a definition item. It also shows...
Hi, I just build a Prusa i3 mk3 and swapped right from the start the Prusa supplied hotend by a new v6 hotend with Micro swiss heatbreak, copper...