Separate names with a comma.
If you want to add a kill switch you can either drill a hole in the LCD panel so you can reach the reset button that's there (but hidden) or you...
Hi Niklas, Make sure you have the sensors plugged in to the correct board. When you turn on extruder 1 make sure that it's extruder 1 temperature...
I just went through something similar with mine. If the LCD backlight comes on then you have plugged in EXP1 into the right connector and the...
Look up onshape. It's pretty easy to use and has good training resources
It's more likely that the bearing has become contaminated with dirt, swarf or something. It doesn't take much to make them run rough. High quality...