Separate names with a comma.
Thank you so much!!! That seems to have been the problem. I removed the Raspberry Pi SD card and just tried the calibration file and it works now....
Tried and failed again... I imported the fff dual profile into S3D and wrote the g-code to the SD card... but it just sits there mocking me :mad:
So, should I just try writing a file to the SD card from S3D and seeing if that the trouble is with the files given on the card? Thanks
Everything else seems to work just fine: https://www.dropbox.com/s/zk1gjpg9htf5gcy/20160428_143206.mp4?dl=0 In the video, I preheated the nozzle...
Unfortunately, no... I tried it before flashing the firmware, and it didn't do anything then, so, I thought that if I flashed it it would fix it...
I used this one: https://github.com/joshuarowley42/BigBox-Dual-Marlin Which I found on and followed the directions on this thread:...
Hello all, So, I got BB all put together, figured out how to flash the firmware from another thread on here, so now the dial turns the right way...
Thanks everyone... that seems to have been the problem... I thought that section was only for AC measurements... now, I know it works for both...
I'm using the multimeter on the 9V DC setting (which they have marked as a Battery setting on the multimeter)... I took some pictures to show you...
So, I'm having trouble getting the potentiometers to tune properly... I'm using an Etek 10709 multimeter on the battery setting and when testing...